Separate Walls With Your Hands
The internal separation of the house always takes the bulk of the time devoted to repair. First of all, they're starting to separate the floor. The black separation consists of dismantling old surfaces. There's a stretch after that. This may be a traditional way, a ceramic or semi-arid ceramsit or semi-arid cement (used with a semi-arid cement mixture and sand with a polypropylene fibrium or an armored net). Regardless of the type of pressure, the demfer tape is used for the quality bay. The next stage of the black division is the gender-restructuring of the GVL.
After we've done the black strip, we're going to decoration. The most frequent use of surface coatings is:
- ceramic stove (contained on the prepared surface, including hypercocarton);
- The natural stone stove (limits, marbles, sunshine and other rocks are durious, beautiful, but sufficiently expensive);
Linoleum (using the substrate and without the substrate);
- Sampling floor (applicable in the kitchen and in the living rooms by virtue of its strength, moisture, surface sensation and style);
- Laminate;
- The fill floor (the mounting is not stacked, but the wooden surfaces are not desirable);
- Soil coating (environmental, pleasant tactile and non-allergic coating based on agawa fibre, but not sufficiently volatile).
Once the floor is separated, the floors shall begin to the walls by mounting plastic wall panels or ceramic plates. In high humidity spaces, a special device is used. And the wooden cells are cultivated. Rosettes should be connected to the ground. The point is, don't forget to make a mounting foam on the components of door boxes and windows.
The simplest way to level the ceiling and give it a decorative view is to set up a river ceiling.
It is recommended that a budget be calculated before proceeding to the premises, that all design elements be carefully considered and that repair materials be purchased. All stages of work can be carried out independently, but to this end the technology, carefulness and verification of all surfaces should be strictly observed.
